steady-state-fate/stereo-dipole
Steady State Fate Stereo Dipole Multimode Filter · Lowpass Filter
20 HP multimode filter and lowpass filter by Steady State Fate: 13 inputs, 5 outputs, 22 controls, 2 modes.
Steady State Fate · SSF Stereo Dipole Cheat Sheet (PDF) ↗
Multimode Filter · Lowpass Filter · Highpass Filter · Bandpass / Notch Filter · Simultaneous Multimode Outputs · Self-Oscillating Filter · 1V/Oct Pitch Tracking · Stereo Inputs / Outputs · Distortion / Saturation · Slew Limiter · LFO
Inputs 13
| Jack | What it does | Range | Connections |
|---|---|---|---|
| INPUT A 816 | filter channel input audio, cv | coupling dc | → DRIVE A, POLE A, DIPOLE A |
| FM-A 816 | FREQ and SPREAD CV cv | — | → POLE A, DIPOLE A attenuated by FM LVL A |
| RES-A 816 | POLE/DIPOLE resonance CV cv | — | → POLE A, DIPOLE A attenuated by RCV LVL A |
| SPRD-A 816 | secondary cutoff CV cv, pitch | scaling v oct | → DIPOLE A |
| V/OCT-A 816 | channel pitch tracking pitch | scaling v oct | → POLE A, DIPOLE A |
| INPUT B 816 | filter channel input audio, cv | coupling dc | normalled from INPUT A → DRIVE B, POLE B, DIPOLE B |
| FM-B 816 | FREQ and SPREAD CV cv | — | → POLE B, DIPOLE B attenuated by FM LVL B |
| RES-B 816 | POLE/DIPOLE resonance CV cv | — | → POLE B, DIPOLE B attenuated by RCV LVL B |
| SPRD-B 816 | secondary cutoff CV cv, pitch | scaling v oct | → DIPOLE B |
| V/OCT-B 816 | channel pitch tracking pitch | scaling v oct | → POLE B, DIPOLE B |
| V/OCT 816 | all-filter pitch tracking pitch | scaling v oct | → POLE A, DIPOLE A, POLE B, DIPOLE B |
| ST-FM 816 | stereo FM CV cv | — | → POLE A, DIPOLE A, POLE B, DIPOLE B attenuated by ST-FM attenuator |
| ST-RES 816 | stereo resonance CV cv | — | → POLE A, DIPOLE A, POLE B, DIPOLE B attenuated by ST-RES attenuator |
The documents don't state: voltage, polarity, audio rate, impedance (all inputs); scaling (INPUT A, FM-A, RES-A, INPUT B, FM-B, RES-B, ST-FM, ST-RES); coupling (FM-A, RES-A, SPRD-A, V/OCT-A, FM-B, RES-B, SPRD-B, V/OCT-B, V/OCT, ST-FM, ST-RES).
Outputs 5
| Jack | What it does | Range | Connections |
|---|---|---|---|
| POLE-A 816 | single peak output audio | — | from POLE A |
| DIPOLE-A 816 | dual peak output audio | — | from DIPOLE A |
| POLE-B 816 | single peak output audio | — | from POLE B |
| DIPOLE-B 816 | dual peak output audio | — | from DIPOLE B |
| DIPOLE AB 816 | quad peak mono output audio | — | from DIPOLE AB |
The documents don't state: voltage, polarity, coupling, impedance (all outputs).
Controls 22
| Control | What it does | Affects | Positions |
|---|---|---|---|
| FREQ A 817 | primary and secondary cutoff knob | POLE A, DIPOLE A | — |
| SPREAD A 817 | secondary cutoff offset knob · -5 to 5 octaves · bipolar | DIPOLE A | — |
| RES A 816 | both peaks resonance knob | POLE A, DIPOLE A | — |
| DRIVE A 816 | pre-filter drive knob | DRIVE A | — |
| POLE type switch A 817 | POLE filter type switch | POLE-A |
|
| DIPOLE type switch A 817 | DIPOLE filter type switch | DIPOLE-A |
|
| routing switch A 816 | DIPOLE serial/parallel routing switch | DIPOLE A, DIPOLE AB |
|
| FM LVL A 816 | bipolar FM attenuator other · bipolar | FM-A, ST-FM | — |
| RCV LVL A 816 | unipolar RES CV attenuator other · unipolar | RES-A | — |
| FREQ B 817 | primary and secondary cutoff knob | POLE B, DIPOLE B | — |
| SPREAD B 817 | secondary cutoff offset knob · -5 to 5 octaves · bipolar | DIPOLE B | — |
| RES B 816 | both peaks resonance knob | POLE B, DIPOLE B | — |
| DRIVE B 816 | pre-filter drive knob | DRIVE B | — |
| POLE type switch B 817 | POLE filter type switch | POLE-B |
|
| DIPOLE type switch B 817 | DIPOLE filter type switch | DIPOLE-B |
|
| routing switch B 816 | DIPOLE serial/parallel routing switch | DIPOLE B, DIPOLE AB |
|
| FM LVL B 816 | bipolar FM attenuator other · bipolar | FM-B, ST-FM | — |
| RCV LVL B 816 | unipolar RES CV attenuator other · unipolar | RES-B | — |
| STEREO FREQ 816 | all four cutoffs knob · -10 to 10 octaves | POLE A, DIPOLE A, POLE B, DIPOLE B | — |
| STEREO RES 816 | bipolar all-filter resonance knob · bipolar | POLE A, DIPOLE A, POLE B, DIPOLE B | — |
| ST-FM attenuator 816 | ST-FM master level other · unipolar | ST-FM | — |
| ST-RES attenuator 816 | ST-RES master level other · unipolar | ST-RES | — |
Blocks 7
| Block | Kind | Types | Inputs | Controls | Outputs | Source |
|---|---|---|---|---|---|---|
| DRIVE A | pre-filter input drive | Distortion / saturation | INPUT A | DRIVE A | — | 817 |
| POLE A | single peak multi-mode VCF | Filter, LFO | FM-A, RES-A, V/OCT-A, V/OCT, ST-FM, ST-RES | FREQ A, RES A, POLE type switch A | POLE-A | 817 |
| DIPOLE A | dual peak multi-mode VCF | Filter, LFO | SPRD-A, FM-A, RES-A, V/OCT-A | SPREAD A, RES A, DIPOLE type switch A, routing switch A | DIPOLE-A | 817 |
| DRIVE B | pre-filter input drive | Distortion / saturation | INPUT B | DRIVE B | — | 817 |
| POLE B | single peak multi-mode VCF | Filter, LFO | FM-B, RES-B, V/OCT-B, V/OCT, ST-FM, ST-RES | FREQ B, RES B, POLE type switch B | POLE-B | 817 |
| DIPOLE B | dual peak multi-mode VCF | Filter, LFO | SPRD-B, FM-B, RES-B, V/OCT-B | SPREAD B, RES B, DIPOLE type switch B, routing switch B | DIPOLE-B | 817 |
| DIPOLE AB | quad peak mono sum | Mixer | — | — | DIPOLE AB | 816 |
Modes 2
Specs 12
| Subject | Quantity | Value | Condition | Source |
|---|---|---|---|---|
| STEREO FREQ | range | -10 to 10 octaves | — | 816 |
| cutoff | total usable range | 17 octaves | — | 816 |
| cutoff | maximum | 50 kHz | — | 816 |
| cutoff | minimum from controls | 0.3 Hz | — | 816 |
| SPREAD | offset range | -5 to 5 octaves | — | 817 |
| self-oscillation | bandwidth | ≥ 20 octaves | — | 817 |
| series POLE+DIPOLE | slope | 24 dB/oct | SERIAL, same filter type | 817 |
| module | width | 20 hp | — | 817 |
| module | depth | 23 mm | — | 817 |
| module | current +12V | 150 mA | — | 817 |
| module | current -12V | 150 mA | — | 817 |
| module | current 5V | 0 mA | — | 817 |
Properties 13
| Subject | Property | Value | Source |
|---|---|---|---|
| inputs | coupling | DC | 816 |
| VCF cores | self-oscillation | yes, any mode | 816 |
| VCF cores | tracking | 1V/OCT | 817 |
| VCF cores | temperature compensated | yes | 817 |
| filter VCAs | type | 2164 | 816 |
| ST-FM | combination | summed with FM-A/B | 816 |
| V/OCT | combination | summed with channel V/OCT | 816 |
| ST-RES | combination | summed with RES-A/B | 816 |
| FM LVL | controls | sum ST-FM and FM | 816 |
| STEREO RES | polarity | bipolar | 816 |
| RGB LEDs | red/green | cutoff above/below 0V | 816 |
| RGB LEDs | blue | resonance depth | 816 |
| module | power protection | reverse, soft start | 817 |
Behavior 12
| Subject | When | Effect | Mode | Source |
|---|---|---|---|---|
| INPUT B | unpatched | receives INPUT A | — | 816 |
| DRIVE | lowest position | passes without gain | — | 816 |
| DRIVE | heavy use | soft then hard clipping | — | 816 |
| SPREAD | center position | matches primary cutoff | — | 817 |
| FM-A/B | negative CV | cutoff below 0.3Hz | — | 816 |
| SPRD-A/B | no attenuator | accurate 1V/OCT secondary | — | 816 |
| FM LVL | center | FM off | — | 816 |
| STEREO RES | roughly center | default position | — | 816 |
| input | gate edges, high resonance | fires pluck | — | 816 |
| DIPOLE filter type | SERIAL mode | affects oscillation tone | — | 816 |
| HP POLE, LP DIPOLE | SERIAL, SPREAD above center | variable width bandpass | — | 816 |
| HP POLE, LP DIPOLE | PARALLEL | variable width notch | — | 816 |
Functions 11
| Function | Basis | Scope | Evidence | Source |
|---|---|---|---|---|
| Multimode Filter | block | patchable | quad multi-mode VCF | 817 |
| Lowpass Filter | control | patchable | LP selectable per POLE/DIPOLE | 817 |
| Highpass Filter | control | patchable | HP selectable per POLE/DIPOLE | 817 |
| Bandpass / Notch Filter | control | patchable | BP selectable per POLE/DIPOLE | 817 |
| Simultaneous Multimode Outputs | jack | patchable | POLE, DIPOLE, DIPOLE AB outputs | 817 |
| Self-Oscillating Filter | property | patchable | resonance self-oscillates any mode | 816 |
| 1V/Oct Pitch Tracking | jack | patchable | V/OCT and V/OCT-A/B inputs | 816 |
| Stereo Inputs / Outputs | jack | patchable | A/B stereo inputs and outputs | 817 |
| Distortion / Saturation | control | patchable | DRIVE soft/hard clipping per channel | 816 |
| Slew Limiter | documented use | patchable | use as complex slew processor | 816 |
| LFO | documented use | patchable | functions as sine wave VCO/LFO | 817 |
Power
| +12 V | 150 mA |
|---|---|
| −12 V | 150 mA |
| +5 V | 0 mA |
| Width | 20 HP |
| Depth | 23 mm |
Other Multimode Filter modules
Sources 2
- [816]
- [817]