mutable-instruments/kinks

Kinks

Mutable Instruments

A 4HP multi-function utility module with three independent sections: a precision inverter and rectifier (SIGN), an analog logic gate pair (LOGIC), and a sample-and-hold with built-in white noise source (S&H).922

Capabilities 5

Analog Logicanalog-logic
LOGIC section outputs analog OR (maximum) and analog AND (minimum) of two inputs, normalized to 0V when unpatched.922
Noise Generatornoise-generator
Built-in white noise generator serves as the S&H signal input normalization source and is independently available at the NOISE output jack.922
Random Sourcerandom-source
922
Rectifierrectifier
SIGN section provides precision inversion, half-wave clipping to 0V, and full-wave rectification (negatives inverted).922
Sample and Holdsample-and-hold
S&H section samples input (normalized to internal noise) on each trigger rising edge and holds the voltage until the next trigger.922

Jacks 12 (5 in / 7 out)

NameSignalVoltageDescription
Inputs (5)
INmixedS&H signal input; normalized to the internal white noise generator when no cable is patched.922
LOGIC AmixedFirst signal input for the LOGIC section; normalized to 0V when unpatched.922
LOGIC BmixedSecond signal input for the LOGIC section; normalized to 0V when unpatched.922
SIGN INmixedSignal input for the SIGN section; accepts audio or CV signals for inversion and rectification.922
TRIGtriggerTrigger input for the S&H section; requires a sharp rising edge and accepts signals up to 10 kHz.922
Outputs (7)
FULLmixedFull-wave rectified output; negatives are inverted, effectively doubling frequency on symmetric waveforms for an octaver effect.922
HALFmixedHalf-wave rectified output; the negative portion of the input is clipped to 0V, adding harmonics to audio signals.922
INVmixedPrecision-inverted version of the SIGN section input signal; useful for inverting envelopes, LFOs, or shaping VCO outputs.922
MAXmixedAnalog OR output, presenting the maximum (peaks) of the two LOGIC input voltages at all times.922
MINmixedAnalog AND output, presenting the minimum (troughs) of the two LOGIC input voltages at all times.922
NOISEaudioWhite noise generator output, available independently of the S&H circuit.922
S&H OUTcvSampled-and-held output voltage; holds the sampled value until the next trigger, drifting toward 0V at less than 0.8mV/s.922

Parameters 1

NameTypeRangeBehavior
TRIGmenu_setting≤10000HzSamples the S&H input on each rising edge; the module responds to the slope of the signal rather than its level, requiring sharp-edged signals up to 10 kHz.922

Firmware history 0 versions

No firmware history recorded.

References 2

  1. [922]
    Kinks Manual (full)manual
    verified 2026-05-24
  2. [923]
    Mutable Instruments Kinks product pageproduct_page
    verified 2026-05-24