instruo/2f
[2]f
Two manual faders providing linear unipolar positive output control voltages, switchable between 0–5V and 0–10V via rear jumpers.929
Capabilities 4
- CV Sourcecv-source
- Each fader sets a unipolar positive DC voltage at its corresponding CV output, switchable between 0–5V and 0–10V ranges via rear jumper.929
- Fader / Slider Bankfader-bank
- Dedicated dual manual fader module outputting unipolar CV — faders as the whole module.
- Manual Controllermanual-controller
- 929
- Offsetoffset
- The [2]f can sum a DC offset with an external CV signal to bias control voltage signals on modules lacking a bias control.929
Jacks 2
| Name | Signal | Voltage | Description |
|---|---|---|---|
| Outputs (2) | |||
| CH1 CV Output | cv | 0V to 10V | Unipolar positive DC control voltage output for channel 1; range is 0–5V or 0–10V depending on rear jumper setting.929 |
| CH2 CV Output | cv | 0V to 10V | Unipolar positive DC control voltage output for channel 2; range is 0–5V or 0–10V depending on rear jumper setting.929 |
Parameters 4
| Name | Type | Range | Behavior |
|---|---|---|---|
| CH1 Fader | fader | ≥0V | Continuously adjusts the DC voltage present at the CH1 CV output; the output range (0–5V or 0–10V) is determined by the rear jumper.929 |
| CH1 Header | jumper | — | Rear jumper for channel 1 selects the output voltage range: uninstalled = 0–5V, installed = 0–10V.929 |
| CH2 Fader | fader | ≥0V | Continuously adjusts the DC voltage present at the CH2 CV output; the output range (0–5V or 0–10V) is determined by the rear jumper.929 |
| CH2 Header | jumper | — | Rear jumper for channel 2 selects the output voltage range: uninstalled = 0–5V, installed = 0–10V.929 |
Firmware history 0 versions
No firmware history recorded.
References 2
- [929]
- [930]