behringer/182
182 Analog Sequencer
Legendary Analog Sequencer Module for Eurorack764
Capabilities 1
- Analog Step Sequenceranalog-step-sequencer
- Two-column 8-step CV sequencer (16 steps in SERIES mode) with gate output, delay/portamento on CV OUT-1, and external clock/trigger I/O.764
Jacks 6 — 2 in / 4 out
| Name | Signal | Voltage | Description |
|---|---|---|---|
| Inputs (2) | |||
| TEMPO CV IN | cv | — | Routes a CV signal to control the internal tempo clock. Can also accept CV fed back from CV OUT-1 or CV OUT-2 to create variable step timing.764 |
| TRIG IN | trigger | — | Accepts an external trigger voltage to advance the sequencer one step at a time when in STEP mode.764 |
| Outputs (4) | |||
| CV OUT-1 | cv | — | Outputs control voltage for CH-1 column steps. Affected by the DELAY control. In SERIES mode, provides the full 16-step sequence output.764 |
| CV OUT-2 | cv | — | Outputs control voltage for CH-2 column steps. Not affected by the DELAY control. In SERIES mode, provides an 8-step output.764 |
| GATE OUT | gate | — | Sends a gate signal for every sequencer step. Gate length is controlled by the GATE TIME knob (10%–90% duty cycle).764 |
| TRIG OUT | trigger | — | Sends a trigger pulse when the sequencer reaches its end step.764 |
Parameters 8
| Name | Type | Range | Behavior |
|---|---|---|---|
| CH-1/CH-2 SEQUENCER COLUMNS | knob | — | Sets the control voltage output for each step. In PARALLEL mode, two independent voltages can be set per step for up to 8 steps. In SERIES mode, sequences of up to 16 steps can be programmed.764 |
| DELAY | knob | 0s – 10s | Sets the slew time (0 to 10 seconds) for shifting to the next step voltage — similar to portamento with an exponential response. Only affects CV OUT-1 in both PARALLEL and SERIES modes; CV OUT-2 is unaffected.764 |
| GATE TIME | knob | 10% – 90% | Controls the duty cycle (10% to 90%) of the GATE OUT signal — the length of time the gate voltage is active per step.764 |
| PARALLEL/SERIES | switch | — | Sliding switch that sets the sequencer to PARALLEL mode (both columns trigger simultaneously, up to 8 steps) or SERIES mode (CH-1 column triggers first then CH-2, enabling 8 to 16 step sequences).764 |
| START/STOP | button | — | Momentary button to start or stop the sequence.764 |
| STEP (REPEAT/SINGLE) | switch | — | Sliding switch with three positions: REPEAT (sequence loops continuously), SINGLE (stops after one full cycle), and STEP (advances one step per trigger received at TRIG IN).764 |
| STEP NUMBER | knob | — | Sets the number of steps before the sequencer restarts. In PARALLEL mode affects both columns simultaneously. In SERIES mode affects only the CH-2 row, enabling sequences of 9 to 16 steps.764 |
| TEMPO | knob | — | Controls the step speed of the sequencer. The internal tempo clock can also be controlled via the TEMPO CV IN jack. CV from CV OUT-1 or CV OUT-2 can be routed back into the clock via TEMPO CV IN to program variable timing between steps.764 |
Firmware history 0 versions
No firmware history recorded.
References 1
-
[764]
Behringer 182 Analog Sequencer manual (mirror of official documentation via device.report)manual● verified 2026-05-22