bastl-instruments/kompas
Kompas
Three-coordinate probabilistic pattern generator with independent traveling algorithms per coordinate, dedicated trigger outputs, and CV-controllable probability per coordinate.735
Capabilities 2
- Probabilistic Pattern Generatorprobabilistic-pattern-generator
- Probability is used to generate new looping patterns rather than filter a pre-determined sequence. Each coordinate knob sets probability amount; CV inputs modulate it externally.735
- Trigger Sequencertrigger-sequencer
- Three independent 32-step trigger sequencers (Longitude, Altitude, Latitude), each with its own traveling algorithm and dedicated trigger output, driven by a global clock input.735
Jacks 8 — 5 in / 3 out
| Name | Signal | Voltage | Description |
|---|---|---|---|
| Inputs (5) | |||
| Altitude CV | cv | 0V to 5V | 735 |
| Clock | clock | — | 735 |
| Latitude CV | cv | 0V to 5V | 735 |
| Longitude CV | cv | 0V to 5V | 735 |
| Reset | gate | — | 735 |
| Outputs (3) | |||
| Altitude Trigger Out | trigger | ≤5V | 735 |
| Latitude Trigger Out | trigger | ≤5V | 735 |
| Longitude Trigger Out | trigger | ≤5V | 735 |
Parameters 4
| Name | Type | Range | Behavior |
|---|---|---|---|
| Altitude | knob | — | Sets the amount of probability for the Altitude coordinate and generates a new 32-step pattern. Fully clockwise: all steps active. Fully counter-clockwise: no steps active. Altitude is always related to the other two coordinates.735 |
| Latitude | knob | — | Sets the amount of probability for the Latitude coordinate and generates a new 32-step pattern. Fully clockwise: all steps active. Fully counter-clockwise: no steps active. Latitude is described as the most unpredictable route.735 |
| Longitude | knob | — | Sets the amount of probability for the Longitude coordinate and generates a new 32-step pattern. Fully clockwise: all steps active. Fully counter-clockwise: no steps active. Knob position acts as offset when CV is applied. Longitude is described as the safest route.735 |
| Trigger Length | jumper | 2ms – 10ms | Selectable at boot by installing a jumper and holding one of the three coordinate knobs: Longitude=2ms, Altitude=5ms, Latitude=10ms. Default is 5ms.735 |
Firmware history 0 versions
No firmware history recorded.
References 2
- [735]
- [736]