2hp/lfo
LFO
Voltage controlled low frequency oscillator with 8 waveforms and smooth morphing between each, two simultaneous outputs, and a reset input for phase sync.375
Capabilities 1
- LFOlfo
- Voltage controlled LFO with 8 waveforms, smooth morphing, two simultaneous outputs, and reset input.375
Jacks 5 (3 in / 2 out)
| Name | Signal | Voltage | Description |
|---|---|---|---|
| Inputs (3) | |||
| Rate CV | cv | 0V to 5V | 375 |
| Reset Input | trigger | — | Resets the phase of both LFO outputs.375 |
| Wave CV | cv | 0V to 5V | Control voltage added to the Wave Knob position for waveform selection.375 |
| Outputs (2) | |||
| Primary Waveform Output | cv | 0V to 5V | Outputs the primary waveform (Cosine, Triangle, Saw, Square) with LED brightness corresponding to output voltage.375 |
| Secondary Waveform Output | cv | 0V to 5V | Outputs the secondary waveform (FM Sines, Inverted Triangle, Ramp, Stepped Triangle) with LED brightness corresponding to output voltage.375 |
Parameters 3
| Name | Type | Range | Behavior |
|---|---|---|---|
| Range Toggle Switch | switch | — | Selects between two LFO rate ranges: Left position gives 27 sec to 20 Hz; Right position gives 3.3 sec to 152 Hz.375 |
| Rate Knob | knob | — | Controls the rate of the LFO. Range depends on Range Toggle Switch position.375 |
| Wave Knob | knob | — | Sets the waveform for both outputs. Interpolates smoothly between all 4 waveform positions. Primary output: Cosine, Triangle, Saw, Square. Secondary output: FM Sines, Inverted Triangle, Ramp, Stepped Triangle.375 |
Firmware history 0 versions
No firmware history recorded.
References 2
- [375]
- [376]