# Warp 1 (Joranalogue Audio Design)

Canonical page: https://eurorackref.com/joranalogue/warp-1/

- id: `joranalogue/warp-1`
- width: 8 HP; depth: 30 mm
- power: +12 V 60 mA, −12 V 60 mA, +5 V ? mA
- status: current
- functions: Distortion / Saturation, Logic Gates, Mixer, Voltage Math / Precision Adder

## Inputs

| Jack | Signals | Function | Voltage | Polarity | Normalled from / comes from | Source |
|---|---|---|---|---|---|---|
| IN 1 | audio, cv | signal input | not stated | not stated | — | 1290 |
| IN 2 | audio, cv | signal input | not stated | not stated | — | 1290 |
| EXP. | cv | exponent CV | not stated | not stated | — | 1290 |
| D/H | gate | direct/hyper gate | not stated | unknown | — | 1290 |
| SCALE | cv | scale CV | not stated | unknown | — | 1290 |
| CLIP- | cv | negative clip CV | not stated | not stated | — | 1290 |
| CLIP+ | cv | positive clip CV | not stated | not stated | — | 1290 |

## Outputs

| Jack | Signals | Function | Voltage | Polarity | Normalled from / comes from | Source |
|---|---|---|---|---|---|---|
| OUT | audio, cv | shaped clipped output | not stated | unknown | precision clipper | 1290 |
| INV. | audio, cv | inverted output | not stated | unknown | precision clipper | 1290 |
| POL. | gate | polarity gate | 0 to 5 V | unipolar | mixer | 1290 |

## Controls

| Control | Type | Function | Range | Affects | Source |
|---|---|---|---|---|---|
| EXPONENT | knob | exponent | 10 to 0.1 exponent (log) | exponentiator | 1290 |
| DIRECT/HYPER | switch | exponent polarity | — | exponentiator | 1290 |
| ABS. | switch | absolute value | — | exponentiator, OUT | 1290 |
| SYMMETRY | knob | input DC offset | -5 to 5 V | mixer | 1290 |
| SCALE | knob | scaling factor | 0.5 to 10 V | exponentiator | 1290 |
| CLIP- | knob | negative clip level | -10 to 0 V | precision clipper | 1290 |
| CLIP+ | knob | positive clip level | 0 to 10 V | precision clipper | 1290 |

## Modes

- direct (DIRECT/HYPER = DIRECT) [1290]
- hyper (DIRECT/HYPER = HYPER) [1290]
- absolute value (ABS. = on) [1290]

## Specs

| Subject | Quantity | Value | Condition | Source |
|---|---|---|---|---|
| module | width | 8 HP | — | 1290 |
| module | depth | 30 mm | including power cable | 1290 |
| module | +12V current | 60 mA | — | 1290 |
| module | -12V current | 60 mA | — | 1290 |
| product page | +12V current | 65 mA | product page figure | 1291 |
| EXPONENT | exponent range | 0.1 to 10 exponent | direct mode | 1290 |
| EXPONENT | exponent range | -10 to -0.1 exponent | hyper mode | 1290 |
| EXP. | CV response | -1 decade per 5 V | — | 1290 |
| SYMMETRY | offset range | -5 to 5 V | — | 1290 |
| SCALE | scale range | 0.5 to 10 V | — | 1290 |
| scale factor | minimum final value | ≥ 1 V | knob plus CV | 1290 |
| CLIP- | clip level range | -10 to 0 V | — | 1290 |
| CLIP+ | clip level range | 0 to 10 V | — | 1290 |
| D/H | Schmitt low threshold | 2 V | — | 1290 |
| D/H | Schmitt high threshold | 3 V | — | 1290 |
| inputs | input impedance | 100 kΩ | — | 1290 |
| POL. | output impedance | 1 kΩ | — | 1290 |
| OUT, INV. | output impedance | 0 Ω | impedance compensated | 1290 |
| module | outer dimensions depth | 43 mm | — | 1290 |
| module | outer width | 50.5 mm | — | 1290 |
| module | mass | 115 g | — | 1290 |

## Behavior

- exponentiator: when EXPONENT centred, direct mode → input passed unchanged (direct) [1290]
- EXPONENT: when turned left → concave curves, thinner sound (direct) [1290]
- EXPONENT: when turned right → convex curves, soft clipping (direct) [1290]
- EXPONENT: when fully clockwise → approaches square wave (direct) [1290]
- EXP.: when CV rises 5 V → exponent ten times smaller [1290]
- D/H: when gate high → inverts switch-selected mode [1290]
- ABS.: when enabled → negative excursions inverted positive (absolute value) [1290]
- CLIP-: when ABS. enabled → negative clipping never occurs (absolute value) [1290]
- SCALE: when ≈5 V, 10 Vpp input → output amplitude constant (direct) [1290]
- scale factor: when knob plus CV below 1 V → limited to above 1 V [1290]
- clip boundaries: when knob plus CV cross 0 V → never cross 0 V [1290]
- POL.: when combined input positive → +5 V [1290]
- POL.: when combined input negative → 0 V [1290]
- CLIPPER LED: when clipped at negative boundary → lights blue [1290]
- CLIPPER LED: when clipped at positive boundary → lights red [1290]
- CLIPPER LED: when no clipping → lights white [1290]
- output: when hyper mode → much louder, sharp swings (hyper) [1290]

## Sources

- [1290] joranalogue Warp 1 manual (manual): https://joranalogue.com/warp-1/manual
- [1291] joranalogue Warp 1 product page (product_page): https://joranalogue.com/collections/all/products/warp-1

Full record as JSON: https://eurorackref.com/joranalogue/warp-1.json
