# àradh (Instruō)

Canonical page: https://eurorackref.com/instruo/aradh/

- id: `instruo/aradh`
- width: 6 HP; depth: 27 mm
- power: +12 V 60 mA, −12 V 40 mA, +5 V ? mA
- status: current
- functions: Lowpass Filter, Self-Oscillating Filter, VCA, Envelope Follower, Logic Gates, Compressor / Dynamics

## Inputs

| Jack | Signals | Function | Voltage | Polarity | Normalled from / comes from | Source |
|---|---|---|---|---|---|---|
| Input | audio | filter and VCA input | not stated | unknown | — | 470 |
| 1V/Oct Input | pitch, cv | cutoff keyboard tracking | not stated | bipolar | — | 470 |
| Strike Input | gate, trigger | impulse envelope trigger | not stated | unknown | — | 470 |
| CV Input | cv | user-defined CV input | not stated | bipolar | Gate/Follow Output signal | 470 |

## Outputs

| Jack | Signals | Function | Voltage | Polarity | Normalled from / comes from | Source |
|---|---|---|---|---|---|---|
| Output | audio | filter and VCA output | not stated | unknown | Low pass filter, VCA | 470 |
| Gate/Follow Output | cv, gate | follower or comparator gate | 0 to 8 V | unknown | Envelope follower, Comparator | 470 |

## Controls

| Control | Type | Function | Range | Affects | Source |
|---|---|---|---|---|---|
| Filter Cutoff Knob | knob | filter cutoff frequency | — | Low pass filter | 470 |
| Resonance Knob | knob | filter resonance | — | Low pass filter | 470 |
| Bias Knob | knob | VCA level | — | VCA | 470 |
| Pre/Post Switch | switch | VCA/filter routing order | — | VCA, Low pass filter, Envelope follower | 470 |
| Strike Button | button | manual impulse trigger | — | Impulse envelope | 470 |
| Decay Knob | knob | impulse envelope decay | — | Impulse envelope | 470 |
| CV Attenuverter | knob | CV Input depth | — | CV Input | 470 |
| CV Assign Button | button | primary CV target | — | CV Input | 470 |
| Gate/Follow Toggle | switch | Gate/Follow Output source | — | Gate/Follow Output | 470 |

## Modes

- Post-filter VCA (Pre/Post Switch = up) [470]
- Pre-filter VCA (Pre/Post Switch = down) [470]
- Envelope follower output (Gate/Follow Toggle = down) [470]
- Comparator gate output (Gate/Follow Toggle = up) [470]

## Specs

| Subject | Quantity | Value | Condition | Source |
|---|---|---|---|---|
| Comparator | threshold voltage | 0 to 5 V | — | 470 |
| CV Input | VCA unity gain voltage | 3.6 V | VCA target, attenuverter fully clockwise | 470 |
| Module | width | 6 HP | — | 470 |
| Module | depth | 27 mm | — | 470 |
| Module | +12V current | 60 mA | — | 470 |
| Module | -12V current | 40 mA | — | 470 |

## Behavior

- Resonance Knob: when fully clockwise → self-oscillates sine [470]
- VCA: when no CV, Bias centred → unity gain [470]
- CV Input: when above 3.6V on VCA → adds gain [470]
- CV Input: when unpatched → follower/gate signal normalled [470]
- CV Input: when filter self-oscillating → acts as FM [470]
- CV Attenuverter: when centred → CV fully attenuated [470]
- CV Attenuverter: when anticlockwise → inverted modulation [470]
- Strike Input: when rising edge → fires impulse envelope [470]
- Strike Button: when signal at Strike Input → lights white [470]
- Envelope follower: when Pre/Post down during setup → follows pre-filter signal [470]
- Envelope follower: when Pre/Post up during setup → follows post-filter signal [470]
- Envelope follower: when active → Strike Button lights amber [470]
- Factory reset: when performed → clears CV targets, follower post-filter [470]
- Filter Cutoff Knob: when filter self-oscillating → sets sine frequency [470]

## Sources

- [470] Instruō àradh User Manual (manual): https://www.instruomodular.com/wp-content/uploads/2023/06/aradh-Manual.pdf
- [471] Instruō àradh product page (product_page): https://www.instruomodular.com/product/aradh/

Full record as JSON: https://eurorackref.com/instruo/aradh.json
