# Oneiroi (Befaco)

Canonical page: https://eurorackref.com/befaco/oneiroi/

- id: `befaco/oneiroi`
- width: 30 HP; depth: 25 mm
- power: +12 V 200 mA, −12 V 80 mA, +5 V 0 mA
- status: current
- functions: Digital / Wavetable Oscillator, 1V/Oct Pitch Tracking, Multimode Filter, Lowpass Filter, Highpass Filter, Bandpass / Notch Filter, Formant / Vocal / Comb Filter, Delay, Reverb, Audio Buffer Recording / Looper, Reverse playback, Stereo Inputs / Outputs, Stereo Panning, Tempo / Clock Sync, LFO, Random / Sample & Hold CV, Envelope Follower, External Audio I/O, Complete Voice

## Inputs

| Jack | Signals | Function | Voltage | Polarity | Normalled from / comes from | Source |
|---|---|---|---|---|---|---|
| Stereo input L(M) | audio | stereo input left | not stated | not stated | — | 643 |
| Stereo input R | audio | stereo input right | not stated | not stated | Stereo input L(M) | 643 |
| Volume CV 1 | cv | source volume CV | 0 to 10 V | not stated | — | 643 |
| Volume CV 2 | cv | source volume CV | 0 to 10 V | not stated | — | 643 |
| Volume CV 3 | cv | source volume CV | 0 to 10 V | not stated | — | 643 |
| Volume CV 4 | cv | source volume CV | 0 to 10 V | not stated | — | 643 |
| Dry/Wet CV 1 | cv | effect dry/wet CV | 0 to 10 V | not stated | — | 643 |
| Dry/Wet CV 2 | cv | effect dry/wet CV | 0 to 10 V | not stated | — | 643 |
| Dry/Wet CV 3 | cv | effect dry/wet CV | 0 to 10 V | not stated | — | 643 |
| Dry/Wet CV 4 | cv | effect dry/wet CV | 0 to 10 V | not stated | — | 643 |
| Sync IN | trigger, clock | external sync | not stated | not stated | — | 643 |
| Record IN | gate | recording gate | not stated | not stated | — | 643 |
| Random IN | trigger, gate | randomize parameters | not stated | not stated | — | 643 |
| V/Oct IN | pitch | pitch for three oscillators | 0 to 10 V | not stated | — | 643 |
| Detune/offset CV | cv | detune/offset CV | -5 to 10 V | not stated | — | 643 |
| Filter cutoff CV | cv | cutoff CV | -5 to 10 V | not stated | — | 643 |
| Resonator tune CV | cv | resonator tune CV | -5 to 10 V | not stated | — | 643 |
| Echo density CV | cv | echo time CV | -5 to 10 V | not stated | — | 643 |
| Ambience spacetime CV | cv | reverb macro CV | -5 to 10 V | not stated | — | 643 |

## Outputs

| Jack | Signals | Function | Voltage | Polarity | Normalled from / comes from | Source |
|---|---|---|---|---|---|---|
| Stereo output L | audio | stereo output left | not stated | not stated | Ambience | 643 |
| Stereo output R | audio | stereo output right | not stated | not stated | Ambience | 643 |

## Controls

| Control | Type | Function | Range | Affects | Source |
|---|---|---|---|---|---|
| Input gain switch | switch | input gain level | — | Input | 643 |
| Pre/Post recording selector | switch | looper record source | — | Looper, Modulation | 643 |
| RECORD button | button | record on/off | — | Looper | 643 |
| VARISPEED | knob | looper speed and direction | -2 to 2 x speed | Looper | 643 |
| START | knob | loop start point | — | Looper | 643 |
| LENGTH | knob | loop size | — | Looper | 643 |
| PITCH | knob | oscillator pitch | -6 to 6 semitones | Sine oscillator, Supersaw/Wavetable | 643 |
| DETUNE | knob | detune / wavetable offset | — | Supersaw/Wavetable | 643 |
| Oscillator Mode Switch | switch | supersaw / wavetable select | — | Supersaw/Wavetable | 643 |
| Shift button | button | secondary functions access | — | — | 643 |
| MOD AMT button | button | mod/CV mapping, save | — | Modulation | 643 |
| MOD LEVEL | knob | modulation master intensity | — | Modulation | 643 |
| SPEED | knob | modulation frequency | — | Modulation | 643 |
| CUTOFF | knob | filter cutoff | 10 to 22000 Hz | Filter | 643 |
| RESONANCE | knob | filter resonance | — | Filter | 643 |
| TUNE | knob | resonator base frequency | — | Resonator | 643 |
| FEEDBACK | knob | resonator feedback | — | Resonator | 643 |
| DENSITY | knob | echo delay time | 10 to 4000 ms | Echo | 643 |
| REPEATS | knob | echo feedback | — | Echo | 643 |
| SPACETIME | knob | reverb size/filter/direction | — | Ambience | 643 |
| DECAY | knob | reverb tail length | — | Ambience | 643 |
| Volume fader (Input) | fader | source volume | — | Mixer Section, Input | 643 |
| Volume fader (Sine) | fader | source volume | — | Mixer Section, Sine | 643 |
| Volume fader (Supersaw/Wavetable) | fader | source volume | — | Mixer Section, Supersaw/Wavetable | 643 |
| Volume fader (Looper) | fader | source volume | — | Mixer Section, Looper | 643 |
| Dry/Wet fader (Filter) | fader | effect dry/wet | — | Mixer Section, Filter | 643 |
| Dry/Wet fader (Resonator) | fader | effect dry/wet | — | Mixer Section, Resonator | 643 |
| Dry/Wet fader (Echo) | fader | effect dry/wet | — | Mixer Section, Echo | 643 |
| Dry/Wet fader (Ambience) | fader | effect dry/wet | — | Mixer Section, Ambience | 643 |
| AMOUNT | switch | randomization amount | — | Randomizer | 643 |
| TARGET | switch | randomization target | — | Randomizer | 643 |
| RANDOM button | button | randomize parameters | — | Randomizer | 643 |

## Modes

- Supersaw (Oscillator Mode Switch = up) [643]
- Wavetable (Oscillator Mode Switch = down) [643]
- PRE (Pre/Post recording selector = PRE) [643]
- POST (Pre/Post recording selector = POST) [643]
- Filter Low-pass [643]
- Filter Band-pass [643]
- Filter High-pass [643]
- Filter Comb [643]
- Filter position I start [643]
- Filter position II resonator-echo [643]
- Filter position III echo-ambience [643]
- Filter position IV end [643]
- Sine LFO [643]
- Ramp LFO [643]
- Sawtooth LFO [643]
- Square LFO [643]
- Sample & Hold [643]
- Chaos [643]
- Envelope Follower [643]
- Modulation mapping [643]
- CV mapping [643]
- Jump Mode [643]
- Catch Mode [643]
- Attenuator Mode [643]
- Attenuverter Mode [643]
- Calibration Mode [643]

## Specs

| Subject | Quantity | Value | Condition | Source |
|---|---|---|---|---|
| Looper | buffer length | 5 s | — | 643 |
| Looper | playback speed | -2 to 2 x | — | 643 |
| Looper | loop length minimum | 8 ms | — | 643 |
| Oscillators | pitch range | 8 octaves | C0 to C7 | 643 |
| PITCH | range | -6 to 6 semitones | — | 643 |
| V/Oct IN | tracking | 10 octaves | 0V to 10V | 643 |
| Supersaw | saws | 7 voices | — | 643 |
| Wavetable | table size | 2048 samples | — | 643 |
| Wavetable | wavetables | 32 count | — | 643 |
| Filter | cutoff | 10 to 22000 Hz | multimode filter | 643 |
| Filter | poles | 2 poles | — | 643 |
| RESONANCE | noise generator threshold | 75 % | — | 643 |
| Resonator | bands | 3 count | — | 643 |
| Echo | time | 10 to 4000 ms | — | 643 |
| Echo | taps | 2 count | — | 643 |
| Sync IN | clock range | 30 to 300 BPM | — | 643 |
| Sync IN | trigger minimum | 1 V | — | 643 |
| internal clock | frequency | 0.2 Hz | no external sync | 643 |
| Modulation | speed multiplier | 0.0625 to 16 x | — | 643 |
| Modulation | frequency | 0.01 to 3 Hz | unsynced | 643 |
| Modulation | max frequency | 80 Hz | — | 643 |
| auto-pan | max rate | 8 x base frequency | — | 643 |
| auto-pan | ratios | 16 count | — | 643 |
| AMOUNT | variation | 20 % | middle position | 643 |
| AMOUNT | variation | 2 % | lower position | 643 |
| audio | bit depth | 24 bit | — | 643 |
| audio | sample rate | 48 kHz | — | 643 |
| audio | internal processing | 32 bit | — | 643 |
| Mixer Section | faders | 8 count | — | 643 |
| CV inputs | primary CVs | 9 count | — | 643 |
| SAVE | hold time | 2 s | — | 643 |
| calibration | source tolerance | 0.005 V | — | 643 |
| module | width | 30 HP | — | 643 |
| module | depth | 25 mm | — | 643 |
| module | current +12V | 200 mA | — | 643 |
| module | current -12V | 80 mA | — | 643 |
| module | current +5V | 0 mA | — | 643 |

## Behavior

- Stereo input R: when unpatched → receives L(M) signal [643]
- Sync IN: when pulse received → looper restarts at START [643]
- Sync IN: when unpatched → internal ~0.2 Hz clock [643]
- Sync IN: when patched or removed → couple seconds to align [643]
- Record IN: when high (>1V) → recording starts [643]
- Record IN: when low (0V) → recording stops [643]
- Random IN: when high (>1V) → parameters randomized [643]
- Random IN: when used → no morphing available [643]
- VARISPEED: when at 12:00 → looper stalled [643]
- VARISPEED: when -1x, 0, 1x → virtual detents [643]
- LENGTH: when minimum → looper acts as oscillator [643]
- looper oscillator: when V/Oct applied → does not track [643]
- SOS: when 0% → old material replaced [643]
- SOS: when 100% → old material never fades [643]
- RECORD button: when held while recording → recording paused [643]
- Volume CV: when jack patched → fader becomes attenuator [643]
- Dry/Wet CV: when jack patched → fader becomes attenuator [643]
- Dry/Wet fader: when lowest position → signal passes unaffected [643]
- External input: when fader up → goes directly to effects [643]
- Oscillator interval: when default 50% → unison [643]
- RESONANCE: when past 75% → chaotic noise added [643]
- chaotic noise: when no input → still audible [643]
- FEEDBACK: when 100% → resonator self-oscillates [643]
- DENSITY: when clock at Sync IN → becomes divider [643]
- SPACETIME: when below 50% → input reversed [643]
- auto-pan: when SHIFT+SPACETIME 0% → no auto-pan [643]
- Modulation: when synced → base frequency from clock [643]
- SPEED: when Envelope Follower type → sets envelope slope [643]
- MOD LEVEL: when always → prevails over all mappings [643]
- Shift button: when LED on → secondary labels prevail [643]
- parameters: when single label → ignore SHIFT [643]
- settings changes: when not saved → lost at power cycle [643]
- Randomizer: when SHIFT + RANDOM → undo; again redo [643]
- Envelope Follower: when PRE → follows module input [643]
- Envelope Follower: when POST → follows module output [643]
- update from v1.0: when after install → configuration erase required [643]

## Sources

- [643] Befaco Oneiroi User Manual (manual): https://befaco.org/docs/Oneiroi/Oneiroi_User_Manual.pdf
- [644] Befaco Oneiroi product page (product_page): https://www.befaco.org/oneiroi/

Full record as JSON: https://eurorackref.com/befaco/oneiroi.json
